NOXYDE®_x000D__x000D_Ultimate corrosion protection, even in severe conditions_x000D__x000D_200% elastic coat does not crack or peel_x000D__x000D_Excellent coverage of nuts, bolts and welds_x000D__x000D_Dry fall: saves preparation & clean up time_x000D__x000D_Primer and topcoat in one_x000D__x000D_UV- and impact-resistant_x000D__x000D_Single pack water-based elastomeric coating based on a modified acrylic binder with unequaled corrosion protection, >15 years in the highest corrosion class C5-M, according to ISO 12944._x000D__x000D_Application type:Airless Spraygun_x000D__x000D_Substrate:Metal, Metal Cladding, Roof _x000D__x000D_Substrate Metal:Aluminium, Bare or blasted metal, Galvanised steel, Non-ferro metal, Prepainted metal, Rusted metal, Stainless Steel _x000D__x000D_Substrate Metal Cladding:Bare or blasted metal, Galvanised Steel, Pre-painted, Rusted Metal, Weathered Plastisol_x000D__x000D_Substrate Roof:Metal Roof, Pre-painted_x000D__x000D_Touch dry:1,5 hours_x000D__x000D_Dry to recoat:24 hours_x000D__x000D_VOC level:15 g/l_x000D__x000D_PRACTICAL CONSUMPTION_x000D_Practical coverage depends on many factors such as porosity and roughness of the substrate_x000D_and material losses during application._x000D__x000D_SURFACE PREPARATION_x000D_Remove grease, oil and all other surface contaminations by alkaline or high pressure (steam)_x000D_cleaning (max. 200 Bars) in combination with appropriate detergents. The substrate has to_x000D_be dust free and made rust free by means of sandblasting (Sa2, St2) or high pressurewater_x000D_jetting (min. 600 Bars). After jetting, the substrate has to be dust free. On newgalvanised_x000D_surfaces, newzinc, aluminium, stainless steel, apply first a coat of Pegalink. On ferrous_x000D_substrates, apply Noxyde in red or grey as the first coat. In all instances apply contrasting_x000D_Noxyde colours for subsequent layers._x000D__x000D_DIRECTIONS FOR USE_x000D_To ensure homogeneity, coating materials should be thoroughly stirred prior to use._x000D__x000D_APPLICATION CONDITIONS_x000D_Temperature between 8 and 55°C / Air humidity max. 80% R.H._x000D_The substrate temperature must be at least 5°C above dewpoint._x000D__x000D_APPLICATION & THINNING: BRUSH_x000D_Undiluted as a rust preventive paint._x000D__x000D__x000D_Diluted with approximately 25% volumewater as an adhesion primer (consumption about_x000D_100 g/m²).